D3D11 moiré effect

[OVH]

Try increasing this value

And what about this "Cluster" audio? They advertise it as replacement for Galaxy

Its a bit better with more channels but its not spectacular and the hit sounds still take over the game sounds. Very bad.
I dont know about Cluster audio I will try it later.


More glitchs:

Vertical lines in explosions I have never seen that before:

Lines1.png (556.73 KiB) Viewed 426 times

Lines2.png (547.51 KiB) Viewed 426 times

And more moiré on the wall in Crescendo:

MoreMoiré.png (1.06 MiB) Viewed 426 times

[Aphex]

Vertical lines in explosions I have never seen that before:

Just checked and it happens on IC Bind only. On regular DX 11 no such issue.

And more moiré on the wall in Crescendo:

Try this:
Set renderer to regular DX 11 (no IC Bind)
Then in Preferences (Console)
Set AA to desired level (or leave at 0)
Then Set LOD Bias to 0 or 1 (don't set too much or distant objects may be very blurry), and Don't set to Negative or will be even more Moire)

advprefs-dx11.jpg (108.43 KiB) Viewed 141 times

dx11-lod0.jpg (920.16 KiB) Viewed 141 times

I think it should look good now

[OVH]

And what about this "Cluster" audio? They advertise it as replacement for Galaxy

I played one map with many players with Cluster audio. Nothing special not better not worse.
But then on map change:

ClusterMusic.png (10.08 KiB) Viewed 140 times

[Aphex]

on map change

And Galaxy just loads "UT Menu" in case of problems. I think better don't use Cluster then. When I tried it, it never worked, but for others it did.

Try LOD Bias and see if it fixes the Moire

[OVH]

I think I found the error: its when I set Use digital music to False. Like in Galaxy.
I dont use UT music.

LODBias is already set to 0.

[Aphex]

LODBias is already set to 0.

And if set to 1?
You can try fraction too (like 0.666667 or 1.333337) to fine-tune